Pppoe - SMC Networks WBR14S-N3 - annexe 1 Manual

• MAC Clone Mode – Some ISPs limit Internet connections to a specified MAC
address of one PC. This setting allows you to manually change the MAC address
of the wireless AP/Router's WAN interface to match the PC's MAC address
provided to your ISP for registration. You can enter the registered MAC address
manually by typing it in the boxes provided. Otherwise, connect only the PC with
the registered MAC address to the wireless AP/Router, then click the "Fill My MAC"
(Default: Disable)

PPPoE

Enable the wireless AP/Router IP address to be assigned automatically from an
Internet service provider (ISP) through an xDSL modem using Point-to-Point
Protocol over Ethernet (PPPoE).
• PPPoE Username – Sets the PPPoE user name for the WAN port.
(Default: pppoe_user; Range: 1~32 characters)
• PPPoE Password – Sets a PPPoE password for the WAN port.
(Default: pppoe_password; Range: 1~32 characters)
• Verify Password – Prompts you to re-enter your chosen password.
• MAC Clone Mode – Some ISPs limit Internet connections to a specified MAC
address of one PC. This setting allows you to manually change the MAC address
of the wireless AP/Router's WAN interface to match the PC's MAC address
provided to your ISP for registration. You can enter the registered MAC address
manually by typing it in the boxes provided. Otherwise, connect only the PC with
the registered MAC address to the wireless AP/Router, then click the "Fill My MAC"
(Default: Disable)
Figure 4-6. Setup Wizard - WAN PPPoE
Using the Setup Wizard
4
4-5