SMC Networks WBR14S-N3 - annexe 1 Manual page 68

5
System Configuration
• Key 1 ~ Key 4 – Sets WEP key values.
The user must first choose between ASCII
or Hexadecimal keys. At least one key
must be specified. Each WEP key has an
index number. The selected key is used
for authentication and encryption on the
VAP interface. Enter key values that
match the key type and length settings.
Standard keys are either 5 or 13
alphanumeric characters; or 10 or 26
hexadecimal digits. (Default: ASCII, no prese
RADIUS
Remote Authentication Dial-in User Service (RADIUS) is an authentication protocol
that uses software running on a central server to control access to RADIUS-aware
devices on the network. An authentication server contains a database of user
credentials for each user that requires access to the network.
A RADIUS server must be specified for the access point to implement IEEE 802.1X
network access control and Wi-Fi Protected Access (WPA) wireless security.
Click "WLAN1/WLAN2 Security" and be sure that an 'Enterprise" mode is selected.
Note: This guide assumes that you have already configured RADIUS server(s) to
support the access point. Configuration of RADIUS server software is beyond the
scope of this guide, refer to the documentation provided with the RADIUS server
software.
RADIUS Setting — Configures RADIUS server settings.
RADIUS settings only apply to WPA, WPA2, or WPA/WPA2 Enterprise
Note:
modes.
• RADIUS Server IP Address – Specifies the IP address of the RADIUS server.
• RADIUS Server Port – The User Datagram Protocol (UDP) port number used by
the RADIUS server for authentication messages. (Range: 1024-65535;
Default: 1812)
5-34
Figure 5-23. RADIUS Settings
t value)