Step 3 - Wan Settings - Pppoe; Figure 17: Wizard Step 3 - Wan Settings - Pppoe - SMC Networks WBR14S-N4 - annexe 1 User Manual

| Initial Configuration
C 4
HAPTER
Setup Wizard
S 3 - WAN
TEP
S - PPP E
ETTINGS O
MAC Clone — Some ISPs limit Internet connections to a specified MAC
◆
address. This setting allows you to manually change the MAC address
of the Wireless Broadband Router's WAN interface to match the PC's
MAC address provided to your ISP for registration. You can enter the
registered MAC address manually by typing it in the boxes provided.
Otherwise, connect only the PC with the registered MAC address to the
Wireless Broadband Router, then click the "Clone your PC's MAC
Address" (Default: Disable)
Enable the Wireless Broadband Router IP address to be assigned
automatically from an Internet service provider (ISP) through an ADSL
modem using Point-to-Point Protocol over Ethernet (PPPoE).

Figure 17: Wizard Step 3 - WAN Settings - PPPoE

The following items are displayed on this page:
User Name — Sets the PPPoE user name for the WAN port.
◆
(Default: pppoe_user; Range: 1~32 characters)
◆ Password — Sets a PPPoE password for the WAN port.
(Default: pppoe_password; Range: 1~32 characters)
Verify Password — Prompts you to re-enter your chosen password.
◆
Operation Mode — Enables and configures the keep alive time and
◆
configures the on-demand idle time.
◆ MAC Clone — Some ISPs limit Internet connections to a specified MAC
address of one PC. This setting allows you to manually change the MAC
address of the Wireless Broadband Router's WAN interface to match the
PC's MAC address provided to your ISP for registration. You can enter
the registered MAC address manually by typing it in the boxes
provided. Otherwise, connect only the PC with the registered MAC
– 44 –