SMC Networks WBR14S-N3 - annexe 1 Manual page 34

4
Initial Configuration
• Password – Sets a PPTP password for the WAN port. (Default: pptp_password;
Range: 1~32 characters)
• Verify Password – Prompts you to re-enter your chosen password.
• Address Mode – Sets a PPTP network mode. (Default: Static)
• IP Address – Sets the static IP address. (Default: 0.0.0.0, available when PPTP
Network Mode is set to static IP.)
• Subnet Mask – Sets the static IP subnet mask. (Default: 255.255.255.0, available
when PPTP Network Mode is set to static IP.)
• Default Gateway – The IP address of the gateway router for the wireless AP/
Router, which is used if the requested destination address is not on the local
subnet.
• MAC Clone Mode – Some ISPs limit Internet connections to a specified MAC
address of one PC. This setting allows you to manually change the MAC address
of the wireless AP/Router's WAN interface to match the PC's MAC address
provided to your ISP for registration. You can enter the registered MAC address
manually by typing it in the boxes provided. Otherwise, connect only the PC with
the registered MAC address to the wireless AP/Router, then click the "Fill My MAC"
(Default: Disable)
Basic Wireless Settings – Configures the SSID and sets the wireless security
5.
policy. Click Apply after completing the setup.
Figure 4-9. Setup Wizard - Basic Wireless Settings
• Network Name (SSID) – The name of the wireless network service provided by
the VAP. Clients that want to connect to the network must set their SSID to the
same as that of the VAP interface. (Default: "SMC"; Range: 1-32 characters)
• Security Policy – Configures the security mode used by clients.
Security" on page 5-28.
4-8
See "WLAN