SMC Networks WBR14S-N3 - annexe 1 Manual page 46

5
System Configuration
• LAN IP Address – Valid IP addresses consist of four decimal numbers, 0 to 255,
separated by periods. The default setting is 192.168.2.1.
• Subnet Mask – Indicate the local subnet mask. (Default: 255.255.255.0.)
• MAC Address – The shared physical layer address for the wireless AP/Router's
LAN ports.
• DHCP Server – Select this option to obtain the IP settings for the access point from
a DHCP (Dynamic Host Configuration Protocol) server. The IP address, subnet
mask, default gateway, and Domain Name Server (DNS) address are dynamically
assigned to the access point by the network DHCP server. (Options: Enable/
Disable)
• Start/End IP Address – Specify the start and end IP addresses of a range that the
DHCP server can allocate to DHCP clients. Note that the address pool range is
always in the same subnet as the unit's IP setting. The maximum clients that the
unit can support is 253.
• Primary DNS Server – The IP address of Domain Name Servers on the network.
A DNS maps numerical IP addresses to domain names and can be used to identify
network hosts by familiar names instead of the IP addresses.
• Secondary DNS Server – The IP address of the Secondary Domain Name Server
on the network.
• Default Gateway – The default gateway is the IP address of the router for the
wireless AP/Router, which is used if the requested destination address is not on
the local subnet.
• Lease Time – Select a time limit for the use of an IP address from the IP pool.
When the time limit expires, the client has to request a new IP address. The lease
time is expressed in seconds. (Default: 86400 seconds; Range: 60~864000
seconds)
• Statically Assigned – Up to three devices with specific MAC addresses can be
assigned static IP addresses. That is, the DHCP server always assigns these
devices the same IP addresses.
• LLTD – Link Layer Topology Discovery (LLTD) is a Microsoft proprietary discovery
protocol which can be used for both wired and wireless networks. (Options:
Disable/Enable, Default: Disable)
• IGMP Proxy – Enables IGMP proxy on the wireless AP/Router. (Options: Disable/
Enable, Default: Disable)
• UPNP – Allows the device to advertise its UPnP capabilities. (Default: Disable)
• Router Advertisement – Enables the sending and receiving of routing
advertisements to discover the existence of neighboring routers. (Options: Disable/
Enable, Default: Disable)
• PPPoE Relay – When enabled, the wireless AP/Router will forward PPPoE
messages to clients. Clients are then able to connect to the PPPoE service through
the WAN port. (Options: Disable/Enable, Default: Disable)
5-12