Displaying The Current Bridge Sta - SMC Networks 6900FSC - annexe 5 Management Manual

Displaying the Current Bridge STA

The parameters shown in the following figure and table describe
the current Bridge STA Information.
Spanning Tree Information : Bridge STA Information
==================================================
Priority
Hello Time (in seconds)
Max Age (in seconds)
Forward Delay (in seconds): 5
Hold Time (in seconds)
Designated Root
Root Cost
Root Port
Reconfig Counts
Topology Up Time
Use <Tab> or arrow keys to move, <Enter> to select.
Parameter
Priority
Hello Time
Max Age
Forward Delay
Hold Time
Designated Root
U S
SING THE YSTEM
: 32768
: 2
: 20
: 1
: 128.0000E800E800
: 501
: 1
: 3
: 48069 (0 day, 1 hr, 2min, 34 sec)
<OK>
Description
Device priority is used in selecting the root device,
root port, and designated port. The device with
the highest priority becomes the STA root device.
However, if all devices have the same priority, the
device with the lowest MAC address will then
become the root device.
The time interval (in seconds) at which the root
device transmits a configuration message.
The maximum time (in seconds) a device can wait
without receiving a configuration message before
attempting to reconfigure.
The maximum time (in seconds) the root device
will wait before changing states (i.e., listening to
learning to forwarding).
The minimum interval between the transmission
of consecutive Configuration BPDUs.
The priority and MAC address of the device in the
Spanning Tree that this switch has accepted as the
root device.
C
ONFIGURATION
P
ROGRAM
2-33