Configuring The Serial Port - SMC Networks 6900FSC - annexe 5 Management Manual

U S
SING THE YSTEM

Configuring the Serial Port

You can access the on-board configuration program by attaching a
VT100 compatible device to the switch's serial port. (For more
information on connecting to this port, see "Required
Connections" on page 1-2.) The communication parameters for
this port can be accessed from the Serial Port Configuration screen
shown below and described in the following table.
<APPLY>
Use <TAB> or arrow keys to move. <Space> to scroll options
Parameter
Management
Mode
Baud rate
Data bits
2-16
C
ONFIGURATION
Serial Port Configuration
=========================
Management Mode
Baud rate
Data bits
Stop bits
Parity
Time-Out (in minutes)
Auto Refresh (in seconds) : 5
Default
Console
Mode
19200
8 bits
P
ROGRAM
: CONSOLE MODE
: 19200
: 8
: 1
: NONE
: 10
<OK>
Description
Indicates that the console port settings are
for direct console connection.
The rate at which data is sent between
devices.
Options : 2400, 4800, 9600, 19200 and auto
detection.
Note that when auto detection is selected,
you need to first press the Enter key once to
set the data rate and initialize the
connection.
Sets the data bits of the RS-232 port.
Options : 7, 8
<CANCEL>