General Maintenance; Calibration & Performance Check Certificates; Service; Safety - Cortexa Technology DermaLab Mini Instructions For Use Manual

17 General maintenance

Maintaining the main unit is limited to cleaning the exterior of the instrument as necessary. Check
the cables and connectors regularly to ensure trouble-free operation.
Maintenance of application probes is described in the relevant application module chapter.
17.1 Calibration & Performance Check Certificates
An increasing demand for documentation to verify that all parts of the equipment are up to spec
and calibrated in accordance with our client's internal quality assurance procedures has led to the
implementation of a special Calibration & Performance Check service.
As a result, all relevant items are marked with a suggested recalibration/check date at time of
shipping. Items returned to Cortex Technology for such service are thoroughly checked, adjusted
and recalibrated as appropriate, and each item is returned with a verification/calibration certificate.
Please contact your local distributor or Cortex Technology for further information.

18 Service

Service and repair of the DermaLab
Cortex Technology.
All probes come pre-calibrated and can be exchanged without any need for recalibrating the main
unit. Please contact your local distributor or Cortex Technology
tex.dk) for requests of service and repair.
Disclaimer: In case the DermaLab
please note: Although we will do our utmost to prevent or minimize loss
of data, Cortex Technology does not warrant that saved measurement
data can be recovered. Please make sure to backup measurement data
regularly.

19 Safety

The external power supply for the DermaLab
cal safety features of the device and must not be tampered with. Do not use any other
power supply than provided by Cortex Technology.
Cortex Technology Aps cannot be held responsible for any damage or loss caused by improper
installation or incorrect use of the device.

20 Warranty


The DermaLab Mini, probes and other accessories are covered by a one-year warranty against
material and manufacturing defects, except
-
Due to the nature of the pH probe, the warranty period is 6 months.
-
Due to the nature of the humidity sensors used in the TEWL probes and the use of these
probes, re-calibration may be needed within the one-year warranty period. Such re-cali-
bration is not covered by the warranty.
®
Mini is only to be performed by authorized personnel or by
®
Mini is sent for repair at Cortex,
®
Mini forms an integral part of the electri-
CORTEX TECHNOLOGY ApS
(www.cortex.dk or cortex@cor-
57/66