Immergas Magis Combo 12 Plus V2 I Instructions And Recommendations page 9

The appliance operates with R410A refrigerant gas.
This gas is ODOURLESS.
Pay the utmost attention
Strictly follow the instruction handbook of the Outdoor Unit before installation and
any type of operation on the chiller line.
Check the environmental operating conditions of all parts relevant to installation, referring to this booklet.
Installation of the appliance when powered by LPG or propane air must comply with
the rules regarding gases with a greater density than air (remember, as an example,
that it is prohibited to install plants powered with the above-mentioned gas in rooms
where the floor is at a lower quota than the country level).
If installing a kit or servicing the appliance, always empty the system's circuit first so as not to compromise the appliance's elec-
trical safety (Parag. 2.9).
Always disconnect the appliance from voltage and, depending on the type of operation, decrease the pressure and/or bring it to
zero in the gas and DHW circuits (when combined with a Storage Tank Unit).
If the appliance is connected to a low temperature direct zone, it is necessary to check the necessary flow rate and possibly add a
relaunch pump.
It is just as important that the intake grids and exhaust terminals are not obstructed.
Check that no flue gas recirculation is found in the air sample points. Allow the
appliance to reach the maximum heat output; theCO
be less than 10% of that measured on the flue gas.
The minimum distance for exhaust pipes from flammable materials must be at least 25 cm.
Keep all combustible material away from the appliance (paper, rags, plastic, polystyrene, etc.).
OK
ST.008706/000
Magis Combo 12/14/16 Plus V2 I
value measured in the air must
2
1
9