Download Print this page

Immergas Magis Combo 12 Plus V2 I Instructions And Recommendations page 11

Advertisement

Pay attention not to generate sparks as follows:
– Do not remove the fuses while the unit is on.
– Do not unplug the unit while it is on.
It is recommended to install the outlet high up. Lay the cables in such a way that they
do not get tangled.
These indoor units, if not adequately isolated, are not suitable for installation on
walls of combustible material.
Wall mounting of the Indoor Unit must guarantee stable and efficient support for
the generator.
The plugs (standard supply) are only to be used to fix the Indoor Unit to the wall; they only ensure adequate support if inserted correctly
(according to technical standards) in walls made of solid or semi-hollow brick or block. In the case of walls made from hollow brick or
block, partitions with limited static properties, or in any case walls other than those indicated, a static test must be carried out to ensure
adequate mount.
This Indoor Unit is used to heat water to below boiling temperature in atmospheric pressure.
They must be connected to a central heating system and domestic hot water circuit suited to their performance and capacity.
The appliance is built to also operate in cooling mode.
If cold water production, during summer, could interfere and damage the central
heating only systems, necessary precautions must be taken to prevent that an
unintentional production of cold water enters the heating only system.
The Storage Tank Unit must also be installed in an environment in which the temperature cannot fall below 0°C.
Risk of damage due to corrosion caused by unsuitable combustion air and environment.
Spray, solvents, chlorine-based detergents, paints, glue, ammonium compounds, powders and similar cause product and flue
duct corrosion.
Check that combustion air power supply is free from chlorine, sulphur, powders, etc.
Make sure that no chemical substances are stored in the place of installation.
If you want to install the product in beauty salons, paint workshops, carpenter's shop, cleaning companies or similar, choose a
separate installation area that ensures combustion air supply that is free from chemical substances.
ST.008706/000
Magis Combo 12/14/16 Plus V2 I
11

Advertisement

loading
Need help?

Need help?

Do you have a question about the Magis Combo 12 Plus V2 I and is the answer not in the manual?

This manual is also suitable for:

Magis combo 14 plus v2 iMagis combo 16 plus v2 iMagis combo 4 plus v2Magis combo 6 plus v2Magis combo 9 plus v2