Immergas Magis Combo 12 Plus V2 I Instructions And Recommendations page 43

1.24 INTERNAL INSTALLATION USING A RECESSED FRAME WITH DIRECT AIR INTAKE
Configuration type B, open chamber and fan assisted
Using a kit separator, one can achieve direct air intake (Fig. 28) and flue exhaust in a single chimney or directly outside.
In this configuration the indoor unit is classified as type B
With this configuration:
- air intake takes place directly from the environment in which the appliance is installed (the recessed frame is ventilated), and only
functions in permanently ventilated rooms;
- the flue gas exhaust must be connected to its own individual chimney and channelled directly into the external atmosphere.
The technical regulations in force must be respected.
Separator kit installation (Fig. 27).
1. Install the discharge flange on the central hole of the indoor unit, positioning the relative gasket with the circular projections down-
wards in contact with the indoor unit flange and tighten using the hex screws with flat tip contained in the kit.
2. Remove the flat flange present in the lateral hole with respect to the central one (according to needs) and replace it with the intake
flange, positioning its gasket already present in the indoor unit and tighten using the supplied self-threading screws.
3. Fit the curves with the male side (smooth) into the female side of the flanges (the intake curve must face the rear side of the indoor
unit).
4. Fit the exhaust pipe with the male side (smooth) to the female side of the bend up to the end stop, making sure that the internal wall
sealing plate has been fitted and connecting the required flue according to personal requirements.
Max. length of exhaust duct.
The maximum lengths ((L max) of the various flues that can be installed are given in the summary table in parag. 1.22.
.
23
ST.008706/000
Magis Combo 12/14/16 Plus V2 I
27
28
43