Immergas Magis Combo 12 Plus V2 I Instructions And Recommendations page 30

1.18 TEMPERATURE CONTROL SETTING
By setting the parameters in the "Heat regulation" menu, you can adjust how the system operates.
The curves (Fig. 16, 18, 17, 19, 20, 21) show the default settings in the various operating modes available both with external probe and
without.
Zone 1 flow temperature in central heating mode
e, with external probe
R04
R05
R02
Zone 1 flow temperature in cooling mode,
with external probe
R13
R12
R11
Key (Fig. 16, 18, 17, 19, 20, 21)
Rxx - Temperature control menu parameter
TE - External temperature
TM - Flow temperature
U 03 - Offset value compared to the curve set by the external probe
on central heating zone 1
U 04 - Offset value compared to the curve set by the external probe
on central heating zone 2
30 Magis Combo 12/14/16 Plus V2 I
U03
R03
U05
R10
flow temperature in central heating mode, with external probe
R08
(R23)
R09
(R24)
R06 (R21)
16
flow temperature in cooling mode, with external probe
(R28)
R17
R16
(R27)
17
U 05 - Offset value compared to the curve set by the external probe
on cooling zone 1
U 06 - Offset value compared to the curve set by the external probe
on cooling zone 2
U 16 - Offset value compared to the curve set by the external probe
on central heating zone 3
U 17 - Offset value compared to the curve set by the external probe
on cooling zone 3
ST.008706/000
Zone 2 (3) mixed
(U16)
U04
R07 (R22)
Zone 2 (3) mixed
(U17)
U06
R15 (R26) R14 (R25)
18
19