RoboLabs Mini Robopop 25 Instruction Manual page 15

5 Cleaning
ALWAYS unplug before cleaning.
•
• DO NOT use excessive water or water jet for machine cleaning. DO NOT spill water on electric
panels or parts. Using excessive water during cleaning can cause short circuit and electric
shock.
• DO NOT immerse machine and/or supply cord into water.
• DO NOT keep supply cord on the floor.
• Internal surfaces are hot. Touching hot surfaces might cause burn. ALWAYS wait until cooled
down before cleaning.
• DO NOT use high alkaline cleaners, sharp items, or abrasives while cleaning.
The purpose of maintenance and cleaning is to keep machine in good condition during all the
lifetime and to meet safety requirements.
5.1 Daily cleaning
1. Unplug the machine. Inspect supply cord, cable plug, and wall receptacle for any
damages. In case of found damages DO NOT use the machine until damaged parts
replaced.
2. Make sure the machine is cooled down.
3. Open the chamber, remove un-popped kernels and debris from perforated bowl.
4. Remove dust from internal surfaces of the chamber with the means of soft dry clean
cloth.
5. Empty the corn bin. Wipe internal surface of the bin to remove dust.
6. Take out and empty the crumb tray. Rinse with water and let it dry before putting back.
7. Clean outer surfaces of the machine with a soft and clean cloth dampened with mild
detergent. Wipe with a clean cloth dampened with water to remove detergent residues.
Let it dry.
14