Snmp - ZyXEL Communications ZYWALL USG CLI Reference Manual

Chapter 34 System Remote Management
Table 156 Command Summary: FTP (continued)
COMMAND
ip ftp server rule {rule_number|append|insert
rule_number} access-group {ALL|address_object}
zone {ALL|zone_object} action {accept|deny}
ip ftp server rule move rule_number to
rule_number
no ip ftp server rule rule_number
show ip ftp server status
34.7.2 FTP Commands Examples
This command sets a service control rule that allowed the computers with the IP addresses
matching the specified address object to access the specified zone using FTP service.
Router# configure terminal
Router(config)# ip ftp server rule 4 access-group Sales zone WAN action
accept
This command displays FTP settings.
Router# configure terminal
Router(config)# show ip ftp server status
active
port
certificate: default
TLS
service control:
No. Zone
========================================================================

34.8 SNMP

Simple Network Management Protocol is a protocol used for exchanging management
information between network devices. Your ZyWALL supports SNMP agent functionality,
which allows a manager station to manage and monitor the ZyWALL through the network.
The ZyWALL supports SNMP version one (SNMPv1) and version two (SNMPv2c).
264
: yes
: 21
: no
Address
DESCRIPTION
Sets a service control rule for FTP service.
address_object: The name of the IP address
(group) object. You may use 1-31 alphanumeric
characters, underscores( ), or dashes (-), but the
_
first character cannot be a number. This value is
case-sensitive.
zone_object: The name of the zone. For the
ZyWALL USG 300 and above, use up to 31
characters (a-zA-Z0-9_-). The name cannot start
with a number. This value is case-sensitive.
The ZyWALL USG 100 and 200 models use pre-
defined zone names like DMZ, LAN1, SSL VPN,
WLAN, IPSec VPN, OPT, and WAN.
Changes the index number of a service control
rule.
Deletes a service control rule for FTP service.
Displays FTP settings.
ZyWALL (ZLD) CLI Reference Guide
Action