Vrrp Synchronization Commands - ZyXEL Communications ZYWALL USG CLI Reference Manual

Table 116 device-ha Commands: VRRP Groups (continued)
COMMAND
[no] description description
[no] activate

23.6.2 VRRP Synchronization Commands

This table lists the commands for synchronization. You can synchronize with other ZyWALL's
of the same model that are running the same firmware version.
Table 117 device-ha Commands: Synchronization
COMMAND
show device-ha sync
show device-ha sync status
[no] device-ha sync from {hostname | ip}
[no] device-ha sync port <1..65535>
[no] device-ha sync authentication password
password
[no] device-ha sync auto
[no] device-ha sync interval <5..1440>
[no] device-ha sync now
ZyWALL (ZLD) CLI Reference Guide
Chapter 23 Device HA
DESCRIPTION
Specifies the description for the specified VRRP
group. The no command clears the description.
description: You can use alphanumeric and
characters, and it can be up
()+/:=?!*#@$_%-
to 60 characters long.
Turns on the specified VRRP group. The
command turns off the VRRP group.
DESCRIPTION
Displays the current settings for synchronization.
Displays the current status of synchronization.
Specifies the fully-qualified domain name (FQDN)
or IP address of the ZyWALL router. Usually, this is
the IP address or FQDN of the virtual router. The
no command clears this field.
hostname: You may up to 254 alphanumeric
characters, dashes (-), or periods (.), but the first
character cannot be a period.
Specifies the port number to use to synchronize
with the specified ZyWALL router. The
command resets the port to 21.
Specifies the password to use when synchronizing.
Every router in the virtual router should use the
same password. The command resets the
no
password to "1234".
password: You can use 4-63 alphanumeric
characters, underscores (_), dashes (-), and
#%^*={}:,.~ characters.
Specifies whether or not to automatically
synchronize at regular intervals.
Specifies the number of minutes between each
synchronization if the ZyWALL automatically
synchronizes with the specified ZyWALL router.
The no command resets the interval to five
minutes.
Synchronize now.
no
no
207