Table of Contents
Advertisement
Chapter 5 Interfaces
The following commands show you how to connect and disconnect ppp0.
Router# interface dial ppp0
Router# interface disconnect ppp0
5.2.10 Auxiliary Interface Commands
The first table below lists the auxiliary
the values you can input with these commands.
Table 30 interface Commands: Auxiliary Interface
COMMAND
interface dial aux
interface disconnect aux
interface aux
[no] phone-number phone
[no] dialing-type {tone | pulse}
[no] port-speed {9600 | 19200 | 38400 |
57600 | 115200}
[no] initial-string initial_string
[no] dial-timeout <30..120>
[no] idle <0..360>
[no] username username
[no] password password
[no] authentication {chap-pap | chap | pap
| mschap | mschap-v2}
64
commands, and the second table explains
interface
DESCRIPTION
Dials or disconnects the auxiliary interface.
Enters sub-command mode.
Specifies the phone number of the auxiliary
interface. You can use 1-20 numbers, commas (,),
or plus signs (+). Use a comma to pause during
dialing. Use a plus sign to tell the external modem
to make an international call. The
clears the phone number.
Specifies the dial type of the auxiliary interface. The
command sets the dial type to tone.
no
Specifies the baud rate of the auxiliary interface.
The
no
command sets the baud rate to 115200.
Specifies the initial string of the auxiliary interface.
The
no
command sets the initial string to "ATZ".
initial_string: You can use up to 64
characters. Semicolons (;) and backslashes (\) are
not allowed.
Specifies the number of seconds the auxiliary
interface waits for an answer each time it tries to
connect. The
command disables the timeout.
no
Specifies the number of seconds the auxiliary
interface waits for activity before it automatically
disconnects. The
no
timeout.
Specifies the username of the auxiliary interface.
The
command clears the username.
no
username: You can use alphanumeric,
underscores (_), dashes (-), and
and it can be up to 30 characters long.
Specifies the password of the auxiliary interface.
The
no
command clears the password.
password: You can use up to 63 printable ASCII
characters. Spaces are not allowed.
Specifies the authentication type of the auxiliary
interface. The
command sets the authentication
no
to chap-pap.
ZyWALL (ZLD) CLI Reference Guide
no
command
command disables the idle
/@$
characters,
Hide quick links:
Advertisement
Table of Contents
