Trunk Command Examples - ZyXEL Communications ZYWALL USG CLI Reference Manual

6.5 Trunk Command Examples

The following example creates a weighted round robin trunk for Ethernet interfaces ge1 and
ZyWALL
ge2. The
Router# configure terminal
Router(config)# interface-group wrr-example
Router(if-group)# mode trunk
Router(if-group)# algorithm wrr
Router(if-group)# interface 1 ge1 weight 2
Router(if-group)# interface 2 ge2 weight 1
Router(if-group)# exit
Router(config)#
The following example creates a least load first trunk for Ethernet interface ge3 and VLAN 5.
ZyWALL
The
Router# configure terminal
Router(config)# interface-group llf-example
Router(if-group)# mode trunk
Router(if-group)# algorithm llf
Router(if-group)# interface 1 ge3
Router(if-group)# interface 2 vlan5
Router(if-group)# exit
Router(config)#
The following example creates a spill-over trunk for Ethernet interfaces ge1 and ge3. The
ZyWALL
sends traffic through ge1 until it hits the limit of 1000 kbps. The
anything over 1000 kbps through ge3.
Router# configure terminal
Router(config)# interface-group spill-example
Router(if-group)# mode trunk
Router(if-group)# algorithm spill-over
Router(if-group)# interface 1 ge1 limit 1000
Router(if-group)# interface 2 ge3 limit 1000
Router(if-group)# exit
Router(config)#
ZyWALL (ZLD) CLI Reference Guide
sends twice as much traffic through ge1.
sends new session traffic through the least utilized of these interfaces.
Chapter 6 Trunks
ZyWALL
sends
77