Alg - ZyXEL Communications ZYWALL USG CLI Reference Manual

C
H A P T E R
This chapter covers how to use the ZyWALL's ALG feature to allow certain applications to
pass through the ZyWALL.
13.1 ALG Introduction
The ZyWALL can function as an Application Layer Gateway (ALG) to allow certain NAT un-
friendly applications (such as SIP) to operate properly through the ZyWALL's NAT.
Some applications cannot operate through NAT (are NAT un-friendly) because they embed IP
addresses and port numbers in their packets' data payload. The ZyWALL examines and uses
IP address and port number information embedded in the VoIP traffic's data stream. When a
device behind the ZyWALL uses an application for which the ZyWALL has VoIP pass through
enabled, the ZyWALL translates the device's private IP address inside the data stream to a
public IP address. It also records session port numbers and allows the related sessions to go
through the firewall so the application's traffic can come in from the WAN to the LAN.
The ZyWALL only needs to use the ALG feature for traffic that goes through the ZyWALL's
NAT. The firewall allows related sessions for VoIP applications that register with a server. The
firewall allows or blocks peer to peer VoIP traffic based on the firewall rules.
You do not need to use STUN (Simple Traversal of User Datagram Protocol (UDP) through
Network Address Translators) for VoIP devices behind the ZyWALL when you enable the SIP

ALG.

ZyWALL (ZLD) CLI Reference Guide
13
ALG
107