Errors In Configuration Files Or Shell Scripts; Zywall Configuration File Details - ZyXEL Communications ZYWALL USG CLI Reference Manual

"exit" or "!'" must follow sub commands if it is to make the ZyWALL exit sub
command mode.
Line 3 in the following example exits sub command mode.
interface ge1
ip address dhcp
!
Lines 1 and 3 in the following example are comments and line 4 exits sub command mode.
!
interface ge1
# this interface is a DHCP client
!
Lines 1 and 2 are comments. Line 5 exits sub command mode.
! this is from Joe
# on 2006/06/05
interface ge1
ip address dhcp
!

35.2.2 Errors in Configuration Files or Shell Scripts

When you apply a configuration file or run a shell script, the ZyWALL processes the file line-
by-line. The ZyWALL checks the first line and applies the line if no errors are detected. Then
it continues with the next line. If the ZyWALL finds an error, it stops applying the
configuration file or shell script and generates a log.
You can change the way a configuration file or shell script is applied. Include
on-error off
the configuration file or shell script and applies all of the valid commands. The ZyWALL still
generates a log for any errors.

35.2.3 ZyWALL Configuration File Details

You can store multiple configuration files on the ZyWALL. You can also have the ZyWALL
use a different configuration file without the ZyWALL restarting.
• When you first receive the ZyWALL, it uses the system-default.conf configuration file of
default settings.
ZyWALL (ZLD) CLI Reference Guide
in the configuration file or shell script. The ZyWALL ignores any errors in
Chapter 35 File Manager
setenv stop-
275