Status Show Commands - ZyXEL Communications ZYWALL USG CLI Reference Manual

C
H A P T E R
This chapter explains some commands you can use to display information about the
ZyWALL's current operational state. You must use the configure terminal command
before you can use these commands.
Table 6 Status Show Commands
COMMAND
show boot status
show cpu status
show disk
show extension-slot
show fan-speed
show mac
show mem status
show ram-size
show redundant-
power status
show serial-number
show socket listen
show socket open
show system uptime
show version
Here are examples of the commands that display the CPU and disk utilization.
Router(config)# show cpu status
CPU utilization: 0 %
CPU utilization for 1 min: 0 %
CPU utilization for 5 min: 0 %
Router(config)# show disk
; <cr>
Router(config)# show disk
No. Disk
===========================================================================
1 image
2 onboard flash
ZyWALL (ZLD) CLI Reference Guide
DESCRIPTION
Displays details about the ZyWALL's startup state.
Displays the CPU utilization.
Displays the disk utilization.
Displays the status of the extension card slot and the USB ports and the names of any
connected devices.
Displays the current fan speed.
Displays the ZyWALL's MAC address.
Displays what percentage of the ZyWALL's memory is currently being used.
Displays the size of the ZyWALL's on-board RAM.
Displays the status of the ZyWALL's power modules. The ZyWALL has two power
modules. It can continue operating on a single power module if one fails.
Displays the serial number of this ZyWALL.
Displays the ZyWALL's listening ports
Displays the ports that are open on the ZyWALL.
Displays how long the ZyWALL has been running since it last restarted or was turned
on.
Displays the ZyWALL's model, firmware and build information.
|
Size(MB)
67
163
Status
Usage
83%
15%
3
31