Zone Commands Summary - ZyXEL Communications ZYWALL USG CLI Reference Manual

Chapter 9 Zones

9.2 Zone Commands Summary

The following table describes the values required for many zone commands. Other values are
discussed with the corresponding commands.s
Table 48 Input Values for Zone Commands
LABEL
profile_name
This table lists the zone commands.
Table 49 zone Commands
COMMAND
show zone [profile_name]
[no] zone profile_name
zone profile_name
[no] block
[no] interface interface_name
[no] crypto profile_name
[no] sslvpn profile_name
92
DESCRIPTION
The name of a zone, or the name of a VPN tunnel.
For the ZyWALL USG 300 and above, use up to 31 characters (a-zA-Z0-9_-). The
name cannot start with a number. This value is case-sensitive.
The ZyWALL USG 100 and 200 models use pre-defined zone names like DMZ,
LAN1, SSL VPN, WLAN, IPSec VPN, OPT, and WAN.
DESCRIPTION
Displays information about the specified zone or
about all zones.
Creates the zone if necessary and enters sub-
command mode. The command deletes the
no
zone.
Blocks intra-zone traffic. The
intra-zone traffic.
Adds the specified interface to the specified zone.
The no command removes the specified interface
from the specified zone. See
49 for information about interface names.
Adds the specified IPSec VPN tunnel to the
specified zone. The no command removes the
specified IPSec VPN tunnel from the specified
zone.
Adds the specified SSL VPN tunnel to the specified
zone. The no command removes the specified
SSL VPN tunnel from the specified zone.
ZyWALL (ZLD) CLI Reference Guide
no command allows
Section 5.2 on page