ZyXEL Communications GS2200-24 Series User Manual page 294

Chapter 32 Access Control
An OID (Object ID) that begins with "1.3.6.1.4.1.890.1.5.8" is defined in private
MIBs. Otherwise, it is a standard MIB OID.
Table 96 SNMP System Traps
OPTION OBJECT LABEL
coldstart coldStart
warmstart warmStart
temperature TemperatureEventOn
TemperatureEventClear
voltage VoltageEventOn
VoltageEventClear
reset UncontrolledResetEventOn 1.3.6.1.4.1.890.1.5.8.55.2
ControlledResetEventOn
RebootEvent
timesync RTCNotUpdatedEventOn
RTCNotUpdatedEventClear 1.3.6.1.4.1.890.1.5.8.55.2
intrusionlock IntrusionLockEventOn
loopguard LoopguardEventOn
fanspeed FanSpeedEventOn
FanSpeedEventClear
294
OBJECT ID
1.3.6.1.6.3.1.1.5.1
1.3.6.1.6.3.1.1.5.2
1.3.6.1.4.1.890.1.5.8.55.2
7.2.1
1.3.6.1.4.1.890.1.5.8.55.2
7.2.2
1.3.6.1.4.1.890.1.5.8.55.2
7.2.1
1.3.6.1.4.1.890.1.5.8.55.2
7.2.2
7.2.1
1.3.6.1.4.1.890.1.5.8.55.2
7.2.1
1.3.6.1.4.1.890.1.5.0.1
1.3.6.1.4.1.890.1.5.8.55.2
7.2.1
7.2.2
1.3.6.1.4.1.890.1.5.8.55.2
7.2.1
1.3.6.1.4.1.890.1.5.8.55.2
7.2.1
1.3.6.1.4.1.890.1.5.8.56.2
7.2.1
1.3.6.1.4.1.890.1.5.8.56.2
7.2.2
DESCRIPTION
This trap is sent when the
Switch is turned on.
This trap is sent when the
Switch restarts.
This trap is sent when the
temperature goes above or
below the normal operating
range.
This trap is sent when the
temperature returns to the
normal operating range.
This trap is sent when the
voltage goes above or below
the normal operating range.
This trap is sent when the
voltage returns to the normal
operating range.
This trap is sent when the
Switch automatically resets.
This trap is sent when the
Switch resets by an
administrator through a
management interface.
This trap is sent when the
Switch reboots by an
administrator through a
management interface.
This trap is sent when the
Switch fails to get the time and
date from a time server.
This trap is sent when the
Switch gets the time and date
from a time server.
This trap is sent when
intrusion lock occurs on a port.
This trap is sent when
loopguard shuts down a port.
This trap is sent when the fan
speed goes above or below the
normal operating range.
This trap is sent when the fan
speed returns to the normal
operating range.
GS2200-24/24P User's Guide