ZyXEL Communications GS2200-24 Series User Manual page 75

The following table describes the labels in this screen.
Table 9 Basic Setting > System Info
LABEL
System
Name
Product
Model
ZyNOS F/W
Version
Ethernet
Address
Hardware Monitor
Temperature
Unit
Temperature
Current
MAX
MIN
Threshold
Status
Fan Speed
(RPM)
Current
MAX
MIN
Threshold
Status
Voltage(V)
Current
MAX
MIN
GS2200-24/24P User's Guide
DESCRIPTION
This field displays the descriptive name of the Switch for identification
purposes.
This field displays the product model of the Switch. Use this information
when searching for firmware upgrade or looking for other support
information in the website.
This field displays the version number of the Switch 's current firmware
including the date created.
This field refers to the Ethernet MAC (Media Access Control) address of the
Switch.
The Switch has temperature sensors that are capable of detecting and
reporting if the temperature rises above the threshold. You may choose
the temperature unit (Centigrade or Fahrenheit) in this field.
BOARD, MAC and PHY refer to the location of the temperature sensors on
the Switch printed circuit board.
This shows the current temperature at this sensor.
This field displays the maximum temperature measured at this sensor.
This field displays the minimum temperature measured at this sensor.
This field displays the upper temperature limit at this sensor.
This field displays Normal for temperatures below the threshold and Error
for those above.
A properly functioning fan is an essential component (along with a
sufficiently ventilated, cool operating environment) in order for the device
to stay within the temperature threshold. Each fan has a sensor that is
capable of detecting and reporting if the fan speed falls below the
threshold shown.
This field displays this fan's current speed in Revolutions Per Minute (RPM).
This field displays this fan's maximum speed measured in Revolutions Per
Minute (RPM).
This field displays this fan's minimum speed measured in Revolutions Per
Minute (RPM). "<41" is displayed for speeds too small to measure (under
2000 RPM).
This field displays the minimum speed at which a normal fan should work.
Normal indicates that this fan is functioning above the minimum speed.
Error indicates that this fan is functioning below the minimum speed.
The power supply for each voltage has a sensor that is capable of
detecting and reporting if the voltage falls out of the tolerance range.
This is the current voltage reading.
This field displays the maximum voltage measured at this point.
This field displays the minimum voltage measured at this point.
Chapter 8 Basic Setting
75