ZyXEL Communications GS2200-24 Series User Manual page 177

Table 46 Advanced Application > Classifier (continued)
LABEL DESCRIPTION
Ethernet Select an Ethernet type or select Other and enter the Ethernet type number in
Type hexadecimal value. Refer to
Source
MAC Select Any to apply the rule to all MAC addresses.
Address
To specify a source, select the second choice and type a MAC address in valid
MAC address format (six hexadecimal character pairs).
Port Type the port number to which the rule should be applied. You may choose one
port only or all ports (Any).
Destination
MAC Select Any to apply the rule to all MAC addresses.
Address
To specify a destination, select the second choice and type a MAC address in
valid MAC address format (six hexadecimal character pairs).
Layer 3
Specify the fields below to configure a layer 3 classifier.
IP Select an IP protocol type or select Other and enter the protocol number in
Protocol decimal value. Refer to
You may select Establish Only for TCP protocol type. This means that the
Switch will pick out the packets that are sent to establish TCP connections.
Source
IP Enter a source IP address in dotted decimal notation.
Address/
Specify the address prefix by entering the number of ones in the subnet mask.
Address
Prefix
A subnet mask can be represented in a 32-bit notation. For example, the
subnet mask "255.255.255.0" can be represented as
"11111111.11111111.11111111.00000000", and counting up the number of
ones in this case results in 24.
Socket
Number
Destination
IP Enter a destination IP address in dotted decimal notation.
Address/
Specify the address prefix by entering the number of ones in the subnet mask.
Address
Prefix
Socket
Number
GS2200-24/24P User's Guide
Table 49 on page 179
Note: You must select either UDP or TCP in the IP Protocol field before
you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select
the second option and enter a TCP/UDP protocol port number. Refer to
50 on page 179 for more information.
Note: You must select either UDP or TCP in the IP Protocol field before
you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select
the second option and enter a TCP/UDP protocol port number. Refer to
50 on page 179 for more information.
Table 48 on page 178 for information.
for more information.
Chapter 20 Classifier
Table
Table
177