ZyXEL Communications GS2200-24 Series User Manual page 204

Chapter 23 Multicast
Note: A port can belong to more than one multicast VLAN. However, IP multicast
group addresses in different multicast VLANs cannot overlap.
Figure 105 Advanced Application > Multicast > Multicast Setting > MVR: Group
Configuration
The following table describes the labels in this screen.
Table 58 Advanced Application > Multicast > Multicast Setting > MVR: Group
Configuration
LABEL
Multicast
VLAN ID
Name
Start
Address
End Address
Add
Cancel
MVLAN
Name
Start
Address
End Address
204
DESCRIPTION
Select a multicast VLAN ID (that you configured in the MVR screen) from
the drop-down list box.
Enter a descriptive name for identification purposes.
Enter the starting IP multicast address of the multicast group in dotted
decimal notation.
Refer to Section on page 192
addresses.
Enter the ending IP multicast address of the multicast group in dotted
decimal notation.
Enter the same IP address as the Start Address field if you want to
configure only one IP address for a multicast group.
Refer to Section on page 192
addresses.
Click Add to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This field displays the multicast VLAN ID.
This field displays the descriptive name for this setting.
This field displays the starting IP address of the multicast group.
This field displays the ending IP address of the multicast group.
for more information on IP multicast
for more information on IP multicast
GS2200-24/24P User's Guide