ZyXEL Communications GS2200-24 Series User Manual page 69

The following table describes the labels in this screen.
Table 7 Status
LABEL
Port
Name
Link
State
PD
LACP
TxPkts
RxPkts
Errors
Tx KB/s
Rx KB/s
Up Time
Clear Counter
GS2200-24/24P User's Guide
DESCRIPTION
This identifies the Ethernet port. Click a port number to display the Port
Details screen (refer to
This is the name you assigned to this port in the Basic Setting > Port
Setup screen.
This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps
or 1000M for 1000Mbps) and the duplex (F for full duplex or H for half).
It also shows the cable type (Copper or Fiber) for the combo ports.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP
state of the port (see Section 13.1 on page 123
If STP is disabled, this field displays FORWARDING if the link is up,
otherwise, it displays STOP.
(for GS2200-24P only) This field displays whether or not a powered
device (PD) is allowed to receive power from the Switch on this port.
This fields displays whether LACP (Link Aggregation Control Protocol) has
been enabled on the port.
This field shows the number of transmitted frames on this port.
This field shows the number of received frames on this port.
This field shows the number of received errors on this port.
This field shows the number of kilobytes per second transmitted on this
port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time in hours, minutes and seconds
the port has been up.
Enter a port number and then click Clear Counter to erase the recorded
statistical information for that port, or select Any to clear statistics for all
ports.
Chapter 7 System Status and Port Statistics
Figure 37 on page 70).
for more information).
69