Configuring Layer 2 Protocol Tunneling - ZyXEL Communications GS2200-24 Series User Manual

27.2 Configuring Layer 2 Protocol Tunneling

Click Advanced Application > Layer 2 Protocol Tunneling in the navigation
panel to display the screen as shown.
Figure 136 Advanced Application > Layer 2 Protocol Tunneling
The following table describes the labels in this screen.
Table 78 Advanced Application > Layer 2 Protocol Tunneling
LABEL
Active
Destination
MAC Address
GS2200-24/24P User's Guide
DESCRIPTION
Select this to enable layer 2 protocol tunneling on the Switch.
Specify a MAC address with which the Switch uses to encapsulate the
layer 2 protocol packets by replacing the destination MAC address in the
packets.
Note: The MAC address can be either a unicast MAC address or
multicast MAC address. If you use a unicast MAC address,
make sure the MAC address does not exist in the address
table of a switch on the service provider's network.
Note: All the edge switches in the service provider's network should
be set to use the same MAC address for encapsulation.
Chapter 27 Layer 2 Protocol Tunneling
253