THORLABS Vytran FFS2001 Series User Manual page 95

FFS2001 Series Chapter 11: Disposal
Proof Test Station
10.7.1 Replace Proof Test Grip
Remove the 4 flat head screws on top of the proof test mandrel and lift off the flanged top. Depress the mandrel
clamp button and remove the rubber grip. Install a new grip making sure that the grip is uniformly positioned
around the mandrel and seated below the bottom flange. Replace the top flange and 4 flat head screws. Make
sure that the mandrel clamp operates freely and that the rubber grip does not rub against the clamping arm. After
replacing the proof test grips, a calibration check should be performed.
Figure 75 Replace Proof Test Grip
Chapter 11 Disposal
Thorlabs verifies our compliance with the WEEE (Waste Electrical and Electronic Equipment) directive
of the European Community and the corresponding national laws. Accordingly, all end users in the EC
may return "end of life" Annex I category electrical and electronic equipment sold after August 13, 2005
to Thorlabs, without incurring disposal charges. Eligible units are marked with the crossed out "wheelie
bin" logo (see right), were sold to and are currently owned by a company or institute within the EC and
are not dissembled or contaminated. Contact Thorlabs for more information. Waste treatment is your own
responsibility. "End of life" units must be returned to Thorlabs or handed to a company specializing in waste
recovery. Do not dispose of the unit in a litter bin or at a public waste disposal site. It is the user's responsibility
to delete all private data stored on the device prior to disposal.
Rev. A, August 14, 2024 Page 89