Sanyo NV-E7000 Installation And Operation Manual page 7

HOW TO INSTALL THE UNIT (1)
PREPARATIONS PRIOR TO INSTALLATION
■ The initial adhesive strength of the double-surface adhesive tape is reduced when the
temperature is low (20°C (68°F) or less). Turn on the heater and heat the vehicle up
prior to adhering onto the mounting surface.
■ Make sure to use the cleaner included with the kit to clean the mounting
surface of any dirt and let the surface dry before adhering the stand base.
The dashboard may have been coated with a wax surface protective agent that
is hard to see with the naked eye. This wax significantly weakens the double-
surface adhesive tape and may cause the unit to fall.
■ The double-surface tape adhering the stand base can only be stuck onto the
surface once and cannot be peeled off and re-adhered.
1
Stand assembly
There are two ways to assemble the stand: with or without the portable DVD navigation
unit mounting stay. Select the assembly method that best suits your vehicle.
q
Method using the portable DVD navigation unit mounting stay
¡The back/forth left/right angles and the vertical positioning are adjustable.
1. 2.
Push the lock release tab Loosen the screw, slide the
and remove the one-touch slider nut through the center
attachable shoe. groove of the portable DVD
navigation unit mounting
Press and
stay and tighten the screw.
Pull out
hold down
Loosen
Angle setting screw
Stand base
Lock release tab
One-touch attachable shoe
Portable DVD navigation
unit mounting stay
4. 3
Mount the unit prepared as described in
stand base.
Slide the one-touch attachable
shoe down through the stand
Make the stand
base until you hear a snap.
perpendicular to
the base.
(see figure)
11
3.
Install the portable DVD
navigation unit mounting
stay onto the unit.
Portable DVD
Navigation System
Coin
Tighten
CAUTION
While pressing the
bottom of the unit,
Slider nut
apply the mounting
The rounded
stay cushion onto the
part is vertical.
Tighten back of the unit.
Applying excessive
force will cause the
disc insert slit cover to
warp which will make
it strike the disc.
onto the
¡Adjust the angle.
Loosen the angle
setting screw and
adjust the back/forth
left/right angles.
After adjustment,
fasten the screw.
¡Removing the portable DVD navigation unit
from the stand base
Press the lock
release tab and
Press pull out the unit.
and hold
down
Pull out
CAUTION Disc replacement is impossible once the unit has been mounted onto the stay.
Replace the disc after removing the unit from the mounting stay.
w
How to mount directly onto the stand base
¡The back/forth left/right angles are adjustable.
1. 2.
Push the lock release tab Remove the slider nut from
and remove the one- the one-touch attachable
touch attachable shoe. shoe.
Press and
hold down
Pull out
Front
NOTE Keep the removed slider nut in a safe place.
It will be necessary when using the portable DVD navigation unit mounting stay.
4. 3
Mount the unit prepared as described in onto
the stand base.
¡Remove the unit from the stand base.
Press and hold down
Pull out backwards
Pull the unit
backwards while
pressing the lock
release tab.
¡Adjust the vertical position
Remove the unit from the stand base and adjust
the position of the one-touch attachable shoe.
Loosen
Tighten
After adjustment,
fasten the screw.
3.
Install the one-touch
attachable shoe onto the
unit.
Slider nut
Front
Tighten
Loosen
Slide the one-touch
attachable shoe down
through the stand base
until you hear a snap.
¡Adjust the angle.
Loosen the angle
setting screw and
adjust the back/forth
left/right angles.
After adjustment,
fasten the screw.
12