2. Installing Options
4.
Loosen the two screws and remove the slot cover.
2
The removed cover will not be reused.
5.
Fully insert the Gigabit Ethernet board.
Confirm that the Gigabit Ethernet board is firmly connected to the controller board.
6.
Tighten the two screws to secure the board.
• Confirm that the Gigabit Ethernet board was correctly installed by printing the configuration page. If
it is correctly installed, "Gigabit Ethernet Board" will appear for "Device Connection" on the config-
uration page.
44
ATU023S
ATU015S
ATU018S