Ricoh Aficio SP C811DN Hardware Manual page 174

9. Troubleshooting
Resetting Job...
The printer is resetting jobs. Wait a while.
Setting change...
The printer is setting changing. Wait a while.
Set the Intermediate Transfer Unit correctly.
The intermediate transfer unit may not be installed correctly. Turn the printer off and re-install the transfer
unit.
If the message is still displayed after re-installation, contact your sales or service representative.
See p.124 "Replacing the Intermediate Transfer Unit and Dustproof Filter" for intermediate transfer unit
installation.
Waiting...
The printer is waiting for the next data to print. Wait a while.
Alert Messages (in alphabetical order)
Cannot print
Check the file you want to print is a supported file type. Check for misfeeds and ask your network admin-
istrator for help.
Connect failed:IEEE802.11b / Turn power off, check card
Check there is an IEEE802.11b interface board installed.
Check that it is a supported board. If it is, check it is installed correctly.
Install the correct board properly.
9
For details, see p.46 "Installing the IEEE 802.11b Interface Unit"
Ethernet Board Error
An error on the Ethernet board is detected. Pull out and then re-install the controller board. If the problem
persists, contact your sales or service representative.
Independent-supply toner
A non-supported toner is installed. Remove it, and install toner specified by an authorized dealer.
Parallel I/F Error
The printer's self diagnostic test failed due to a loopback error. Replace the IEEE 1284 board that caused
the error.
For details, see p.52 "Installing the IEEE 1284 Interface Board"
Printer Font Error
There are problems with the printer's font file.
172