Panasonic WJ-ND300A Setup Instructions page 74

I Send to
Enter the mail addresses of the recipient of the alarm
mail and the warning report mail. Enter the mail
addresses of the recipients for "Address1" - "Address4".
Enter up to 255 alphanumeric characters including
hyphens (-), periods (.) and at mark (@). Up to 4 desti-
nations can be registered.
Check the desired mail type (warning/alarm) to be sent.
Settings relating to Panasonic Protocol [Panasonic Alarm protocol]
Perform the settings to notify a PC of event/error occurrence.
To receive a notification (or error information) and display the contents of the notification, the optional software (WV-
AS65) is necessary.
Screenshot 1
Click the [Comm] button in the setup menu (Advanced)
and then click "Panasonic Alarm protocol" to display the
"Panasonic Alarm protocol" window.
74
I From Address
Enter the mail address of a sender. Entered mail
addresses will be displayed in the "From" (sender) line.
Enter up to 127 alphanumeric characters including
hyphens (-), periods (.), at mark (@) and underscores
(_).
Note:
The following alphanumeric characters can be
entered.
A B C D E F G H I J K L M N O P Q R S T U V W X
Y Z a b c d e f g h i j k l m n o p q r s t u v w x y z 0 1
2 3 4 5 6 7 8 9 ! " # $ % & ' ( ) * + , - . /: ; < = > ? @ [
\ ] ^ _ ` { | } ~
Step 1
Perform the settings for the following items.
I Port Number (to PC)
Enter a port number to be used for the PC.
I Retry
Set the retry number of the transmission to the PC.
I Destination Address
Enter the address of the recipient. Enter the IP address
or host name for "Address1" - "Address4".
Up to 4 destinations can be registered.
Enter up to 255 alphanumeric characters including
hyphens (-), periods (.) and underscores (_).
Step 2
Click the [SET] button after completing the settings.