Panasonic WJ-ND300A Setup Instructions page 36

I Port Setup
Perform the settings for the following items for each
port.
[DHCP]
Select ON or OFF to determine whether or not to use
the DHCP server.
Select "ON" to obtain an IP address, a subnet mask and
a gateway address from the DHCP server. Set to "OFF"
when entering the addresses above manually.
ON: Uses the DHCP server.
OFF: Does not use the DHCP server.
[IP Address]
When "OFF" is selected for "DHCP", enter an IP
address. For this unit, enter 4 units from the decimal
numbers (0-254).
[Subnet Mask]
Enter a subnet mask according to the network configu-
ration when OFF is selected for "DHCP".
[Gateway]
Enter the IP address of the gateway according to the
network environment when "OFF" is selected for
"DHCP".
[Line Speed]
The following are available for "Line Speed".
AUTO: Line speed will be applied automatically.
10-HALF: 10 Mbps semi duplex
10-FULL: 10 Mbps full duplex
100-HALF: 100 Mbps semi duplex
100-FULL: 100 Mbps full duplex
Note:
When the setup menu is closed after changing the
line speed, the unit will automatically restart.
36