Panasonic WJ-ND300A Setup Instructions page 65

[Port Forwarding Setup]
Select "ON" or "OFF" to determine whether or not to set
the port forwarding.
The camera setup menu can be displayed only when
"ON" is selected for "Port Forwarding" on the setup
menu (Advanced) ("Comm" - "Basic Setup" - "Port
Forwarding").
[Port Setup]
Set the port numbers used to connect each camera.
I HTTP Port Number
Specify the HTTP port number to be used to send
images from the unit. A number from 1 - 65535 is avail-
able. It is unnecessary to change it for normal use.
Notes:
• Depending on the network settings of the LAN or
Internet service provider, network communication
may not be established if the http port number has
been changed. In this case, refer to the administra-
tor of the network.
• The following port numbers and the port numbers
used for the FTP port, the site alarm settings, and
the port forwarding are unavailable for the HTTP
port numbers.
20, 21, 23, 25, 42, 53, 67, 68, 69, 79, 105, 110, 123,
161, 162, 546, 547, 995, 10001, 10002, 10003,
10004, 10005, 10006, 10007
I FTP Port Number
Specify the FTP port number to be used.
Note:
The following port numbers and the port numbers
used for the HTTP port, the site alarm settings, and
the port forwarding are unavailable for the FTP port
number.
20, 23, 25, 42, 53, 67, 68, 69, 79, 80, 105, 110, 123,
161, 162, 546, 547, 995, 10001, 10002, 10003,
10004, 10005, 10006, 10007
I Port Setup
Perform the settings for the following items for each port
(camera port, client PC port and maintenance port).
[DHCP]
Select ON or OFF to determine whether or not to use
the DHCP server.
Select "ON" to obtain an IP address, a subnet mask and
a gateway address from the DHCP server. Set to "OFF"
when entering the addresses above manually.
ON: Uses the DHCP server.
OFF: Does not use the DHCP server.
[IP Address]
When "OFF" is selected for "DHCP", enter an IP
address. For this unit, enter 4 units from the decimal
numbers (0-254).
[Subnet Mask]
Enter a subnet mask according to the network configu-
ration when OFF is selected for "DHCP".
[Gateway]
Enter the IP address of the gateway according to the
network environment when "OFF" is selected for
"DHCP".
[Line Speed]
The following are available for "Line Speed".
AUTO: Line speed will be applied automatically.
10-HALF: 10 Mbps semi duplex
10-FULL: 10 Mbps full duplex
100-HALF: 100 Mbps semi duplex
100-FULL: 100 Mbps full duplex
Notes:
• It is impossible to change the line speed of the main-
tenance port.
• When the setup menu is closed after changing the
line speed, the unit will automatically restart.
65