Panasonic WJ-ND300A Setup Instructions page 32

Setup items
I REC Type
Select "QUICK" or "ADVANCED" for validation of the recording settings.
QUICK: The recording settings set on the setup menu (Quick) will be validated when recording.
ADVANCED: The recording settings set on the setup menu (Advanced) will be validated when recording.
It is possible to check if the set recording rate and transmission rate are available for the network in use by clicking
the [Measurement] button. It will take around 90 seconds to check. In the process of measurement, recording and
copying will stop.
When the set rate is displayed red, recording/transmission may be failed with the set rate.
Notes:
• When "QUICK" is selected, the setup menu (Quick) will be displayed by clicking the [Setup] tab. When
"ADVANCED" is selected, the setup menu (Advanced) will be displayed by clicking the [Setup] tab.
• When "QUICK" is selected, the following setup items of "Schedule" (Advanced) will not function. When it is nec-
essary to function the following items, select "ADVANCED".
Submenu
Time Table
Program
Special Days
* To perform the schedule recording, perform the settings for "Time Table" and "Program".
• When "QUICK" is selected, MPEG-4 live image will not be displayed and recording will not be performed.
Check if the result value (total value of the maximum network speed of each camera) is below the maximum network
speed of the unit (50 Mbps as indication).
When the result value is beyond the maximum network speed of the unit (50 Mbps as indication)
(Example: 50 Mbps < 60 Mbps (result value))
When the result value is beyond the maximum network speed of the unit (50 Mbps as indication), refer each rate for
"LIVE VIDEO", "MANUAL REC", "SCHEDULE REC" and "EVENT REC". Then, lower the higher rate among them or
lower image quality to diminish the network traffic from the camera. Click the [Measurement] button to check if the
result value is below the maximum network speed. Repeat this procedure until the result value becomes less than
50 Mbps (as indication).
32
Setup items
"FTP SEND BY PERIODIC TIMER"
"WARNING REPORT MAIL"
"FTP ALARM SENDING"
"ALARM MESSAGE"
"Panasonic Alarm Protocol"
"ALARM MAIL"
Program 1 - 4
Status
Disabled
Disabled
Disabled
Functions normally (Fixed to "ON".)
Disabled
Disabled
The settings performed on the setup menu
(Advanced) will not be validated.
The settings performed on the setup menu
(Quick) will be validated. *
Disabled