■
Insert the power cord plug securely into the wall outlet.
•
If the plug is not inserted correctly, electric shocks or overheating could result.
•
Do not use plugs which are damaged or wall outlets which are coming loose from the wall.
■
Do not place the projector on top of surfaces which are unstable.
•
If the projector is placed on top of a surface which is sloped or unstable, it may fall down or tip over,
and injury or damage could result.
■
Do not place the projector into water or let it become wet.
•
Failure to observe this may result in fire or electric shocks.
■
Do not disassemble the lamp unit.
•
If the lamp section breaks, it may cause injury.
■
Do not place liquid containers on top of the projector.
•
If water spills onto the projector or gets inside it, fire or electric shocks could result.
•
If any water gets inside the projector, contact an Authorized Service Center.
■
Do not insert any foreign objects into the projector.
•
Do not insert any metal objects or flammable objects into the projector or drop them onto the projector,
as doing so can result in fire or electric shocks.
■
After removing the battery from remote control unit, keep it away from
the reach of children.
•
The battery can cause death by suffocation if swallowed.
•
If the battery is swallowed, seek medical advice immediately.
■
Do not allow the + and - terminals of the battery to come into contact
with metallic objects such as necklaces or hairpins.
•
Failure to observe this may cause the battery to leak, overheat, explode or catch fire.
•
Store the battery in a plastic bag and keep it away from metallic objects.
■
Insulate the battery using tape or similar before disposal.
•
If the battery comes into contact with metallic objects or other batteries, it may catch fire or explode.
■
Replacement of the lamp unit should be carried out by a qualified
technician.
•
The lamp unit has high internal pressure. If improperly handled, failure might result.
•
The lamp unit can easily become damaged if struck against hard objects or dropped, and injury or
malfunctions may result.
■
When installing to a ceiling, be sure to use the accessory wire (install
in a different location to the ceiling mount bracket) and the eye bolts
as an extra preventative measure to stop the projector from falling
down.
•
If the projector is not secure enough, accidents may result.
■
Do not place sets directly on top of each other.
•
If this is not observed, accidents may result.
■
Do not use the projector while the projection lens cover is still
attached to the projection lens (sold separately).
•
If this is not observed, fire may occur.
7
ENGLISH –