Procedure Of Installation - Panasonic PT-D10000 Operating Instructions Manual

Installation of input module (optional) (continued)
■

Procedure of installation

Disconnect the power before installing the input module.
1. Remove the slot cover. 1. Remove the slot cover.
2. Insert the input module. 2. Insert the input module.
3. Fix the input module. 3. Fix the input module.
4. Register the input signal. 4. Register the input signal.
• • This projector needs to register the type of This projector needs to register the type of
input signal after the installation of the input input signal after the installation of the input
module. module.
• • For details on the registration of the input For details on the registration of the input
signals, refer to pages 40-42. signals, refer to pages 40-42.
28
– ENGLISH
IN IN OUT OUT MENU MENU
RS-232C IN RS-232C IN RS-422 IN RS-422 IN RS-422 OUT RS-422 OUT
REMOTE 1 REMOTE 1 REMOTE 2 IN REMOTE 2 IN SERIAL SERIAL LAN LAN
POWER ON POWER ON STANDBY STANDBY
VIDEO VIDEO
IN IN R/P R/P R R G/Y G/Y B/P B/P B B
S-VIDEO S-VIDEO
RGB1 RGB1
SYNC/HD SYNC/HD VD VD
OUT OUT
AUTO AUTO
VIDEO VIDEO S-VIDEO IN S-VIDEO IN RGB 1 IN RGB 1 IN RGB 2 IN RGB 2 IN DVI-D IN DVI-D IN
SETUP SETUP
RGB2 RGB2
DVI-D DVI-D
AUX AUX
OFF OFF ON ON
AC IN AC IN MAIN POWER MAIN POWER
Slot Cover Slot Cover
LENS LENS
ENTER ENTER
SHUTTER SHUTTER
LIGHT LIGHT
ON ON
OFF OFF
Remove 2 screws. Remove 2 screws.
Input module Input module
Tighten the two screws. Tighten the two screws.
Slot Slot