Panasonic PT-D10000 Operating Instructions Manual page 42

Registration of input signal data (continued)
2. Press ▲▼◄► to select the SUB
MEMORY number stored in the
"SUB MEMORY LIST".
3. Press ENTER.
• A "Change registered signals" screen will
appear.
REGISTER SUB MEMORY? REGISTER SUB MEMORY?
NAME NAME
MEMORY NO MEMORY NO
INPUT INPUT
fH fH
fV fV
SYNC.STATE SYNC.STATE
REGISTER REGISTER
ENTER ENTER
4. Press ENTER.
Note
• To rename a registered signal, perform steps 4 and
5 on page 41.
■
Procedure to switch to sub
memory
1. Press ◄► on normal screen
(menu is not displayed).
• The screen will show a list of the sub-memory
registered for the currently entered signal.
2. Press ▲▼◄► to select the
sub-memory signal to be
switched in the "SUB MEMORY
LIST".
3. Press ENTER.
• Signal will be switched to the one that was
selected in Step 2.
■
How to erase sub memory
The currently selected SUB MEMORY is deleted
by pressing DEFAULT at the "REGISTERED
SIGNAL LIST".
42
– ENGLISH
SXGA60-A1 SXGA60-A1
-- --
RGB1 RGB1
64.00kHz 64.00kHz
60.00Hz 60.00Hz
H(POS) H(POS)
V(POS) V(POS)
■
On-screen indications
# Input switching / signal switching
This shows the registered signal name on the
status screen for signal switching.
INPUT INPUT RGB1 RGB1
NAME NAME RGB RGB
MEMORY NO MEMORY NO A1(1-2) A1(1-2)
$ Details of registered signal
REGISTERED SIGNAL STATUS REGISTERED SIGNAL STATUS
NAME NAME
SXGA60-A1 SXGA60-A1
MEMORY NO MEMORY NO A1(1-2) A1(1-2)
INPUT INPUT
RGB1 RGB1
fH fH
fV fV
SYNC.STATE SYNC.STATE
H(POS) H(POS)
V(POS) V(POS)
RENAME RENAME
ENTER ENTER
• The designation can be set by the sub memory
items.
• MEMORY NO : A1 (1-2)
Sub memory number Sub memory number
The place in which address code (A1, The place in which address code (A1,
A2, ..., H7 and H8) signals are registered A2, ..., H7 and H8) signals are registered
Note
Restrictions
• The maximum sub memory items that can be
registered for the projector are 96 including the
basic signal.
63.98kHz 63.98kHz
60.02Hz 60.02Hz