Panasonic PT-D10000 Operating Instructions Manual page 18

Using the remote control unit (continued)
Note
• The Remote Control may not function properly if an
object is in the light path.
• The Remote Control receiver may not function
properly in intense ambient light such as fluorescent
lamps. Carefully site the projector so its Remote
Control receiver windows will not be directly
exposed to intense light.
Setting projector ID
number to remote control
Every projector has its ID number and the ID number
of the controlling projector must be set to the remote
control in advance so that the user can operate
the remote control. (p. 75) The ID number of the
projector is set to "ALL" on shipping, and use the
ID ALL button of the remote control when using
only a single projector.
1. Press ID SET, and then within
5 seconds, press the two
numeric (0-9) buttons which
correspond to the ID number that
has been set for the projector.
Attention
• Do not press the ID SET button accidentally or
carelessly because the ID number on the Remote
Control can be set even when no projector is
around.
• If you do not enter the two-digit ID number within
5 seconds after the ID SET button has been
pressed, the ID number will remain at the number
that was set before the ID SET button was pressed.
• Your specified ID number is stored in the remote
control unit unless another one is specified later.
However, the stored ID will be erased if the batteries
of the remote control are left exhausted. When the
batteries are replaced, set the same ID number
again.
18
– ENGLISH
Using a wired remote
control
When multiple main units are connected as part of
the system, connect to units with a M3 stereo mini
jack cable (sold separately) to simultaneously control
multiple main units with a single remote control
through the REMOTE1 IN/OUT terminal. It is effective
to use the wired remote control in the environment in
which an obstacle stands in the light path or where
devices are susceptible to outside light.
Connect to the secondary projector Connect to the secondary projector
M3 stereo mini pin-PIN cable M3 stereo mini pin-PIN cable
(sold separately) (sold separately)
Remote Control Remote Control
Attention
• Use a two-wire shielded cable with a length of 15 m
or less. If the length of the cable exceeds 15 m, the
shielding of the cable may not be sufficient and the
remote control may not work.
Connection terminals Connection terminals