Panasonic PT-D10000 Operating Instructions Manual page 69

6. Use the colorimeter to
measure the luminance (Y) and
chromaticity coordinates (x, y).
7. Press ▲▼ to select the colors,
and press ◄► to select their
values.
8. After all the data has been input,
press MENU.
• The "MEASURE MODE" screen will be
displayed.
MEASURE MODE MEASURE MODE
MODE MODE
MEASURED DATA MEASURED DATA
TARGET DATA TARGET DATA
AUTO TESTPATTERN AUTO TESTPATTERN
MENU SELECT MENU SELECT
SUB MENU SUB MENU
ENTER ENTER
■
Inputting the coordinates of a
desired color
9. Press ▲▼ to select "MODE".
10. Press ▲▼ to select "7COLORS".
11. Press ▲▼ to select "TARGET
DATA".
12. Press ENTER.
• The "TARGET DATA" screen will be displayed.
TARGET DATA TARGET DATA
TARGET DATA:R,G,B TARGET DATA:R,G,B
TARGET DATA:Cy,Mg,Ye,Wh TARGET DATA:Cy,Mg,Ye,Wh
MENU SELECT MENU SELECT
SUB MENU SUB MENU
ENTER ENTER
13. Press ▲▼ to select "R, G, B" or
"Cy, Mg, Ye, Wh".
14. Press ENTER.
• The "TARGET DATA: R, G, B (or "Cy, Mg, Ye,
Wh")" screen will be displayed.
TARGET DATA: R, G ,B TARGET DATA: R, G ,B
x x
R R
y y
x x
G G
y y
x x
B B
y y
MENU SELECT MENU SELECT
ADJUST ADJUST
15. Press ▲▼ to select the desired
colors, and press ◄► to input
their coordinates.
709MODE 709MODE
ON ON
0.670 0.670
0.330 0.330
0.650 0.650
0.630 0.630
0.150 0.150
0.050 0.050
16. After all the data has been input,
press MENU.
Note
• If "3COLORS" or "709MODE" has been selected as
the "TARGET MODE" setting, only the 3 colors R, G
and B will be input for "TARGET DATA".
• If "709MODE" has been selected as the "TARGET
MODE" setting, the 3 primary colors defined by the
ITU-R BT.709 standard will be set as the target
data.
• If the target data is outside the color range of the
projector, the colors will not be projected correctly.
Large Screen Correction
If watching images close up on a large screen, you
can correct the colors that appear lighter on the
screen so that they appear the same as the colors
that would appear on a normal-sized screen.
1. Press ▲▼ to select "LARGE
SCREEN CORRECTION".
OPTION1 OPTION1
COLOR MATCHING COLOR MATCHING
LARGE SCREEN CORRECTION LARGE SCREEN CORRECTION
AUTO SIGNAL AUTO SIGNAL
AUTO SETUP AUTO SETUP
BACK COLOR BACK COLOR
DVI EDID DVI EDID
AUX DVI EDID AUX DVI EDID
P IN P P IN P
FUNC1 FUNC1
OSD POSITION OSD POSITION
OSD MEMORY OSD MEMORY
MENU SELECT MENU SELECT
CHANGE CHANGE
2. Press ◄► to switch "LARGE
SCREEN CORRECTION".
• The setting will change as follows each time
◄► is pressed.
OFF (No correction)
2 (High)
OFF OFF
OFF OFF
OFF OFF
BLUE BLUE
EDID2(PC) EDID2(PC)
EDID2(PC) EDID2(PC)
OFF OFF
P IN P P IN P
2 2
ON ON
1 (Low)
ENGLISH –
69