Panasonic PT-D10000 Operating Instructions Manual page 25

Example of connecting with VIDEO devices
Video deck (TBC built-in) Video deck (TBC built-in)
Color monitor Color monitor Video deck (TBC built-in) Video deck (TBC built-in)
Attention
• When connecting with a video deck, be sure to use the one with a built-in time base corrector (TBC) or use a
TBC between the projector and the video deck.
• If nonstandard burst signals are connected, the image may be distorted. If this is the case, connect a TBC
between the projector and the video deck.
Note
• The DVI-D signal input terminal supports only a single link.
• The HDMI-DVI-D conversion cable is required to connect an HDMI-compliant device.
• The EDID mode setting must be selected so that it corresponds to the device to be connected. (pp. 71, 72)
• It is possible to connect the DVI-D input terminal with an HDMI- or DVI-D-compliant device, but with some
devices the images may not appear or other problems may be encountered in operation.
Control PC Control PC
IN IN OUT OUT
RS-232C IN RS-232C IN
REMOTE 1 REMOTE 1 REMOTE 2 IN REMOTE 2 IN
R/P R/P G/Y G/Y
IN IN R R
SYNC/HD SYNC/HD
OUT OUT
VIDEO VIDEO S-VIDEO IN S-VIDEO IN RGB 1 IN RGB 1 IN
High-vision video deck High-vision video deck
Control PC Control PC Control PC Control PC
RS-422 IN RS-422 IN
RS-422 OUT RS-422 OUT
SERIAL SERIAL LAN LAN
B/P B/P
B B
VD VD
RGB 2 IN RGB 2 IN
DVI-D IN DVI-D IN
Red (connected to P Red (connected to P terminal) terminal)
R R
Blue (connected to P Blue (connected to P terminal) terminal)
B B
Green (connected to Y terminal) Green (connected to Y terminal)
DVD player with HDMI DVD player with HDMI
(HDCP) terminal (HDCP) terminal
ENGLISH –
25