Connection - Panasonic PT-D10000 Operating Instructions Manual

Connection

Before starting connection
• Before connection, read carefully the instruction manual for the device to be connected.
• Turning off the power switch of the devices before connecting cables.
• If any connection cable is not supplied with the device, or if no optional cable is available for connection of the
device, prepare a necessary system connection cable to suit the device.
• Video signals containing too much jitter may cause the images on the screen to randomly wobble or wafture. In
this case, a time base corrector (TBC) must be connected.
• The projector accepts the following signals: video, S-Video, analog RGB, DVI-D and signals which are compatible
with the optional input module (p. 27).
• Some PC models cannot be connected to the projector.
●
The pin-out and signal names of the S-VIDEO IN terminal are shown in the diagram below.
Outside view Outside view
●
The pin-out and signal names of the RGB2 IN terminal are shown in the diagram below.
Outside view Outside view
&, -, 0, and 3 are not assigned.
( - +, . and / are GND terminals.
●
The pin-out and signal names of the DVI-D IN terminal are shown in the diagram below.
= =
4 4
+ +
Outside view Outside view
24
– ENGLISH
Pin No. Pin No.
# #
$ $
% %
& &
Pin No. Pin No.
# #
$ $
% %
1 1
2 2
5 5
Pin Pin
No. No.
- -
# #
T.M.D.S data 2– T.M.D.S data 2–
$ $
T.M.D.S data 2+ T.M.D.S data 2+
# #
% %
T.M.D.S data 2 / 4 shield T.M.D.S data 2 / 4 shield
& &
( (
) )
DDC clock DDC clock
* *
DDC data DDC data
+ +
- -
T.M.D.S data 1– T.M.D.S data 1–
. .
T.M.D.S data 1+ T.M.D.S data 1+
/ /
T.M.D.S data 1 / 3 shield T.M.D.S data 1 / 3 shield
0 0
Ground (luminance signal) Ground (luminance signal)
Ground (color signal) Ground (color signal)
Luminance signal Luminance signal
Color signal Color signal
R/P R/P
R R
G/G • SYNC/Y G/G • SYNC/Y
B/P B/P
B B
HD/SYNC HD/SYNC
VD VD
Pin Pin
Signal Signal
No. No.
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
: :
; ;
= =
Signal Signal
Signal Signal
Signal Signal
+5V +5V
Ground Ground
Hot plug detection Hot plug detection
T.M.D.S data 0- T.M.D.S data 0-
T.M.D.S data 0+ T.M.D.S data 0+
T.M.D.S data 0 / 5 shield T.M.D.S data 0 / 5 shield
T.M.D.S clock shield T.M.D.S clock shield
T.M.D.S clock+ T.M.D.S clock+
T.M.D.S clock– T.M.D.S clock–