Mounting Instructions - Distech Controls ECLYPSE ECY-400 Series Installation Manual

Using the Reset Button
Depending on the amount of time the reset button is held down, different actions are taken by the controller. The STATUS LED will turn off after each
time interval.
Hold Reset For
5 seconds
10 seconds
20 seconds
Always backup the controller's license through the controller's Web interface before you hold the controller's reset button for 20 seconds.
Once the controller reboots, you will have to install the license through the controller's Web interface.
After you hold the controller's reset button for 20 seconds, the controller's HTTPS security certificates will be regenerated. If you use HTTPS
to connect to the controller, you will no longer be able to connect to the controller from any PC that was used in the past to connect to the
controller unless you delete the old HTTPS security certificate from these PCs.
Connecting an RTC Adapter to the Clock Port
For installations where long-term power outages are expected (e.g., schools during summer break) or where there is no internet connection, an adapter
(can be purchased separately as an accessory) can be used to add a CR2032 pill battery to provide additional power to the controller's Real Time Clock.
Connect the RTC adapter to the Clock port located on the bottom of the controller (see Figure 8, above) and make sure the switch is set to ON.
Figure 7: Dimensions of the Distech Controls RTC battery adapter (sold separately)

Mounting Instructions

Ensure that the mounting surface can support the controller, DIN rail, and any site-supplied enclosure.
Mounting Positions
The controller can be mounted horizontally or vertically to a vertical wall surface.
There is no restriction on the orientation of the controller as long as the internal temperature does not exceed the maximum operating temperature. How-
ever, the horizontal orientation provides the best heat dissipation.
DIN Rail-Mounted Installation
Figure 8: Typical DIN Rail-Mounting Release Clip
To
Restart / reboot the controller.
Reset both Ethernet and Wi-Fi IP addresses back to factory default settings.
Reset the controller to its factory default settings. User accounts (user names and passwords) will also be reset to the
factory default settings and the controller license will be cleared.
Din Rail Release Clip
5 / 15