Kyocera KM-5050 Operation Manual page 50

Preparation before Use
Item
Host Name
IP Address
Subnet Mask
Default Gateway
DHCP/BOOTP
RARP
DNS Server
(Primary, Secondary)
Domain Name
WINS Server
(Primary, Secondary)
Scope ID
FTP Status Check
2-14
The settings to be specified in the TCP/IP settings screen are explained
below.
Specifies a name for the machine system network component. This name is also
used as the NetBEUI Printer Name and the SNMP sysName object.
Assigns the Internet Protocol address on the machine system network
component. The format of the IP Address is four-byte (32-bit) numbers separated
by dots, e.g. 192.168.48.21.
Specifies the subnet mask configured on the machine system network
component. If the machine system does not automatically assign a usable default
value and the first number in the IP address is from 192 to 254, then use
255.255.255.0 as the subnet mask.
The IP address of the gateway router for the local network.
Identifies how the machine obtains its IP configuration: DHCP/BOOTP: automatic
configuration via a BOOTP server or a DHCP server.
Automatic configuration using the Reverse Address Resolution Protocol.
The IP address of the primary and secondary Domain Name System (DNS)
servers.
The Domain Name System (DNS) to which the machine system belongs, such as
abcdnet.com. It should not include the host machine name.
The IP address of the primary and secondary Windows Internet Name Service
(WINS) servers.
This section determines the scope of IP addresses that a Windows server can
grant or lease to any requesting network component. A DHCP server processes
the machine system's discovery broadcasts and returns an IP address to it. The
DHCP server may be set up to grant an IP address for a limited time (a
temporary lease) or for an unlimited time (an unlimited lease), or it may be
configured with a permanent address reservation for the machine system.
Enables or disables the FTP Status Check.
3
Click Submit.
4
After completing the settings, restart the machine to save the settings.
Description
OPERATION GUIDE