Kyocera KM-5050 Operation Manual page 175

Symptom
Printouts are dirty.
Images are skewed.
Paper often jams.
Printouts from the
document processor
have black lines.
Printouts are
wrinkled.
Cannot print.
Documents are
printed improperly.
OPERATION GUIDE
Checkpoints
Is the platen or the document
processor dirty?
Is the transfer roller dirty?
Are the originals placed
correctly?
Is the paper loaded
correctly?
Is the paper loaded
correctly?
Is the paper of the supported
type? Is it in good condition?
Is the paper curled, folded or
wrinkled?
Are there any loose scraps or
jammed paper in the
machine?
Is the slit glass dirty?
Is the paper separator of the
paper feed unit dirty?
Is the machine plugged in?
Is the machine powered on?
Is the printer cable
connected?
Was the machine powered
on before the printer cable
was connected?
Is Press Status Key...
displayed at the top of the
screen?
Are the application software
settings at the PC set
properly?
Corrective Actions
Clean the platen or the document
processor.
Brush the transfer roller clean.
When placing originals on the
platen, align them with the original
size indicator plates.
When placing originals in the
optional document processor, align
the original width guides securely
before placing the originals.
Check the position of the paper
width guides.
Load the paper correctly.
Remove the paper, turn it over, and
reload it.
Replace the paper with new paper.
Remove any jammed paper.
Clean the slit glass.
Clean the paper separator.
Plug the power cord into an AC
outlet.
Turn on the main power switch.
Connect the correct printer cable
securely.
Power on the machine after
connecting the printer cable.
Press the Status/Job Cancel key,
[Printing jobs], and then [Resume
All Print Jobs] to restart printing.
Check that the printer driver and
application software settings are
set properly.
Troubleshooting
Reference
Page
5-2
5-5
2-47
2-47
2-48
2-34
2-34
2-34
6-12
5-3
5-4
—
3-2
2-3
2-3
—
—
6-3