Kyocera KM-5050 Operation Manual page 181

Error Message
Reset all originals in
document processor.
Scanner memory is
full.
Send Error.
Job is canceled. Press
[End].
####
OPERATION GUIDE
Checkpoints
Are there any originals left in
the document processor?
–
Is the acceptable scanning
count exceeded?
–
Corrective Actions
Remove originals from the document
processor.
Scanning cannot be performed due
to insufficient memory of scanner.
The job is canceled. Press [End].
Press [Continue] to print, send or
store the scanned pages. Press
[Cancel] to cancel printing, sending
or storing.
An error has occurred during
transmission. The possible error
codes and their descriptions are as
follows.
1101: The server name of the SMTP
server is not set correctly or the host
name is incorrect when sending scan
data to an FTP server. Use
COMMAND CENTER and register
the SMTP server name and the host
name correctly.
1102: The login user name is
incorrect or the domain name has not
been entered. Enter login user name,
domain name and password
correctly.
1103: The network path name is
incorrect or you do not have access
to the folder specified. Use
COMMAND CENTER and register
the path name correctly.
1104: No recipient address. Enter E-
mail address correctly.
1105: E-mail - The SMTP protocol
setting is turned off. Use COMMAND
CENTER and turn on the SMTP
protocol setting.
Scan to PC (SMB) - SMB setting is
turned off. Use COMMAND CENTER
and turn on the SMB setting.
Scan to PC (FTP) - FTP setting is
turned off. Use COMMAND CENTER
and turn on the FTP setting.
1106: The sender address setting
under E-mail: SMTP is not registered.
Use COMMAND CENTER and
register the sender address.
Troubleshooting
Reference
Page
—
—
—
2-15
—
3-22
3-23
2-15
2-15
6-9