Assembly; Installation - Jet JMD-18 Operator's Manual

Assembly
1. Screw plastic knob (A, Fig. 1) onto handle shaft
(B, Fig. 1). Screw handle shaft into downfeed
hub (C, Fig. 1) and tighten. Flat spot on shaft
accommodates a combination or adjustable
wrench. Note: Handle shafts are already
installed into hub on JMD-18PFN.
2. Repeat for other two shaft assemblies.
3. Slide crank (A, Fig. 2) onto shaft and tighten set
screw (B, Fig. 2). Be sure set screw seats on flat
part of shaft.
4. Insert handle (C, Fig. 2) into crank and tighten.
5. Slide handwheel (A, Fig. 3) onto table
handwheel shaft and tighten set screw. Insert
handle (B, Fig. 3) into handwheel and tighten.
6. Repeat for two remaining table hand wheels.
Installation
1. The location for the mill/drill should be well lit,
dry, and have room enough to allow the head to
rotate 3600.
2. Place nylon slings with a load rating exceeding
the weight of the mill/drill around the head so
that the sling will not damage any parts when
tensioned. See Fig. 4.
3. Carefully lift the mill/drill to a sturdy stand or work
bench. For best performance, through bolt the
mill/drill to a bench or stand.
4. Before bolting the mill/drill to a bench or stand,
the unit must be level in both directions. Place a
level on the table in both directions.
5. If the table is not level, shim under the low corner
(s) untilleve!. Tighten the fastening bolts.
Check for level again. Adjust as necessary until
Fig. 1
Fig. 2
~.
Fig. 3 ...
V\
J)
5