Table of Contents
Related Manuals for Jet JNS-4031KL
Summary of Contents for Jet JNS-4031KL
- Page 1 Operating and Maintenance Instructions 3/8-inch Reversible Air Drill Model JNS-4031KL 427 New Sanford Road LaVergne, Tennessee 37086 Part No. M-JNS4031KL Ph.: 800-274-6848 Revision A1 05/2014 www.jettools.com Copyright © 2014 JET...
-
Page 2: Warranty And Service
JET sells through distributors only. The specifications listed in JET printed materials and on official JET website are given as general information and are not binding. JET reserves the right to effect at any time, without prior notice, those alterations to parts, fittings, and accessory equipment which they may deem necessary for any reason ®... - Page 3 5. Do not use this tool for other than its intended use. If used for other purposes, Jet disclaims any real or implied warranty and holds itself harmless from any injury that may result from that use.
-
Page 4: Specifications
Net Weight (lbs.) ..........................2.76 The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations. -
Page 5: Operation
4. Change filters on the air system on a regular [*NOTE: Air tool oil not provided. It may be basis. purchased from your JET dealer, or is available at most major hardware and tool 5. Air line pressure should be increased stores. -
Page 6: Troubleshooting
Troubleshooting Trouble Probable Cause Remedy Air pressure is too low. Adjust air pressure to 90psi. Air lines are twisted, or there is a Untwist or clean out air lines. blockage in them. Drill does not operate Air compressor is malfunctioning, or is at normal speed. - Page 8 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools.com...