Contents Of The Shipping Container; Unpacking And Clean-Up; Tools Needed For Assembly; Jmd-18/18Pfn...........................................................................................................................1 - Jet JMD-15 Owner's Manual

Contents of the Shipping Container

1. Mill/Drill Machine
Accessory Package:
1. 1/2" Drill Chuck w/ Chuck Key
1. Adjustable Carbide Facemill
1. Facemill Arbor
2. Bolts, Nuts, and Washers to
Attach Vise to Table
1. 2-1/2" Angle Vise (JMD-15)
1. 3-1/2" Angle Vise (JMD-18/18PFN)
3. Handle Rods
3. Rubber Knobs
1. 3/8"x1" Hex Socket Cap Screw
1. 3/8" Washer
1. Crank Body
1. Crank Handle
1. 3mm Hex Wrench
1. 5mm Hex Wrench
1. 23mm Hex Socket Wrench (JMD-
18/18PFN)
3. Hand Wheels w/ Handles
1. Can Touch-Up Paint
1. Owner's Manual
1. Warranty Card
1. Lifting Hook

Unpacking and Clean-up

1. Finish removing the crate from the mill/drill.
Unbolt the machine from the crate bottom.
Report shipping damage, if any, to your
distributor.
2. Clean all rust protected surfaces using a
mild commercial solvent, kerosene or diesel
fuel. Do not use paint thinner, gasoline, or
lacquer thinner. These will damage painted
surfaces. Cover all cleaned surfaces with a
light film of Mobil DTE

Tools Needed for Assembly

8" Adjustable Wrench or 1/4" to 1-1/4"
Combination Wrench Set
Oil Heavy Medium.
6
(JMD-18 shown with optional CS-18 stand)