Controls - Jet JMD-18 Operator's Manual

The JMD-18/18PFN is rated at 230V only. Again, be
sure the power source is compatible with the mill/drill
before connecting to the power source.
Controls
Longitudinal Hand Wheels (X-axis)(A, Fig. 6) -
located on either side of the table. Moves table side
to side.
Cross Feed Hand Wheel (Y-axis) (8, Fig. 6) -
located on the front of the base. Moves table toward
or away from the column.
Adjustable Table Stops (C, Fig. 6) - located on
table front. Adjust to stop table at any setting along
the longitudinal axis.
Table Locks (D & E, Fig. 6) - longitudinaltable (0,
Fig. 5) locks are located on front of the table. Cross-
feed table locks (E, Fig. 6) are located on the right
side under the table. Turn clockwise to lock.
Depth Stop (A, Fig. 7 - JMD-18) or (A, Fig. 8 - JMD-
15) -located on the left side (JMD-15) or center
(JMD-18) of the quill assembly. Set knurled nuts
(JMD-15) or turn knurled knob (JMD-18) or set the
depth stop on the power down feed assembly (JMD-
18PFN) to desired depth for repetitive drilling to the
same depth.
Downfeed Handle (8, Fig. 7) - located on the right
side of the head casting. Counter-clockwise
movement advances the quill toward the table.
Return spring retracts the handle.
Fine Feed Hand Wheel (C, Fig. 7) - located on the
front of the head casting. To activate, turn the power
feed speed range dial to zero and pull the down feed
handles away from the column.
c
Fig. 6
Fig.7
Fig. 8
7